From the profile, it can be seen that the wave peaks are relatively large, and there are grooves on the wave peaks, which is to enable the fixture of the photovoltaic bracket to be clamped on it. What are the advantages of our photovoltaic roof color steel tile machine?

1.Save costs

Color steel sheet has been in use since the ‎‎ 80s ‎, many factory buildings have used color steel sheet, but over time, the color steel sheet of these factory buildings has shown a series of problems such as corrosion, rust, etc. What should be done at this time?
If the roof tiles are removed and new ones are installed, a lot of funds will be needed.In addition the construction is very dangerous,so, we research and development of this kind of roof tile, is directly on the original roof again fitted with a layer of equivalent to let the customer only spend the cost of a new roof.
The traditional photovoltaic model involves adding an additional layer of material on the roof and installing photovoltaic panels. As a result, the load-bearing capacity of the roof increases significantly, and so does the cost. However, the color steel tiles made by our equipment can be directly equipped with photovoltaic brackets on them. In this way, the costs from multiple aspects are integrated, and the cost is reduced to the minimum.

2.Excellent configuration

The double-edged cutter is adopted to ensure that the plate shape does not deform during the cutting process. After the blade has been used for a long time, the tightness of the blade can be adjusted through the nut. Moreover, we have installed an automatic oiling setting on the cutting knife, which allows for the setting of the oiling frequency. It does not rely on human consciousness and is convenient for the maintenance of the machine.
The direction setter is installed on the forming machine, which is used for the lifting and lowering of the shaft above. Because this equipment of our can not only produce single-layer color steel sheets, but also composite material color steel sheets.For instance, materials with pixel sponge attached or insulation layers are prone to warping and unevenness. Our equipment is capable of flattening both ordinary and composite materials
In order to make it more convenient to adjust the shafts at the top and bottom, we added a steering gear.Some customers are limited by the size of the factory area. Therefore, we integrate the control system, hydraulic system and machines together to reduce the floor space occupied by the equipment.
The diameter of the roller of the forming machine has exceeded 160mm, with strong stability and fast forming speed.
Equipment with a side roller, but side roller easily become loose or bad regulation in the long-term work, so we add the nut, used to enhance stability, convenient adjustment.

Some customers may ask us why the price of the equipment is higher than that of others? The fundamental reason is still the high cost. We can't sell it below the cost. If you need a long-term stable and durable device, we hope you can choose our Cangzhou Zhongtuo Company.